+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: KC868-A series and Uair Smart Controller (https://www.kincony.com/forum/forumdisplay.php?fid=6)
+--- Thread: Newbie question (/showthread.php?tid=7659)
Newbie question - DK5EW - 02-20-2025
Hi all,
first I`m not a programmer or software guy I just want to use my KinCony A16S 16 Channel ESP32 for switching the relay outputs.
First problem is how do I connect the board with LAN ? I connected it to PC and I see a ethernet but I can`t get access to the IP 192.168.1.200
Second I want to use Tuya I leard that I have put in the purchased code but first I have to connect but this failed.
So any help hwo to connect to the board with PC over LAN are very welcome. I searched for document or video but did not find anything.
regards
RE: Newbie question - admin - 02-20-2025
do you have download KCS v2 firmware by USB-C cable firstly? because new board without firmware inside of ESP32.
here is KCS v2 online guide: https://www.kincony.com/esp32-kcsv2-firmware.html
RE: Newbie question - classiccars - 03-14-2025
I see this screen (pic attached) after connection with KC868-A16v3
Must I load the firmware there?
where are instructions?
RE: Newbie question - admin - 03-14-2025
this is esphome yaml file , photo use by A16v3.
if you are using KC868-A16S, you should use KC868-A16S' esphome yaml file: https://www.kincony.com/forum/showthread.php?tid=2789
RE: Newbie question - classiccars - 03-14-2025
(03-14-2025, 09:51 AM)admin Wrote: this is esphome yaml file , photo use by A16v3.
if you are using KC868-A16S, you should use KC868-A16S' esphome yaml file: https://www.kincony.com/forum/showthread.php?tid=2789
My device is KC868-A16v3
Wich firmware must I load?
RE: Newbie question - admin - 03-14-2025
if you are using KC868-A16v3, you should download KCS v3 firmware:
https://www.kincony.com/forum/showthread.php?tid=7783