+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=62)
+--- Forum: F16 (https://www.kincony.com/forum/forumdisplay.php?fid=63)
+--- Thread: I may have fried my board (/showthread.php?tid=7837)
I may have fried my board - Read.0h1 - 03-19-2025
I think I may have messed up some wiring of input sensors. I think I may have accidentally plugged in a 12v power supply into a digital input or maybe some wires made contact with each other after stapling them into the wall.
The device went offline at about the time that I was working on it according to home assistant and now the device won’t go online but the lights still work along with all manual controls.
Is there any trouble shooting I can do or a way to reset the device other than unplugging and replugging?
RE: I may have fried my board - admin - 03-19-2025
you can download KCS firmware again to test the board.
digital input can work with 12v DC level.