+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: Suggestions and feedback on KinCony's products (https://www.kincony.com/forum/forumdisplay.php?fid=39)
+--- Thread: E16V3 - baudrate change (/showthread.php?tid=8980)
E16V3 - baudrate change - ldebacker - 02-02-2026
Hello,
Is there a way to change the default RS485 baudrate (which is 38400 bps) ?
Any existing register to change the RS485 parameters ?
Thanks in advance !
RE: E16V3 - baudrate change - admin - 02-03-2026
how to change baud rate:
step1: modbus 06 command write address 2 (data:0-4 0：4800，1：9600，2：19200，3：38400，4：57600)
step2: modbus 05 command write address 501 = true will save the config.
step3: power off->on of board.
if forget the setting. hold on the "RESET" button > 3 seconds, it will auto set to default setting with 38400bps.
RE: E16V3 - baudrate change - ldebacker - 02-08-2026
Many thanks for your reply.
I will try the procedure.
As a suggestion, I think it would be good to include the tip in the instructions manual.
Best regards,
Laurent
RE: E16V3 - baudrate change - admin - 02-08-2026
thanks for your suggestion. we already have updated modbus protocol document.