+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: KC868-HxB series Smart Controller (https://www.kincony.com/forum/forumdisplay.php?fid=2)
+--- Thread: KC868-A8 on Heat Pump for SG-Ready (/showthread.php?tid=9311)
KC868-A8 on Heat Pump for SG-Ready - ssopiadis - 05-03-2026
I bought a KinCony kc868-a8 for a custom project.
With this I want to control (amongst other things) through SG-Ready a heat pump (ALSAVO Air Source Heat Pump Monoblock - 7kW).
The documentation of the heat pump (https://rjwebshop.dk/upload_dir/shop/Zealux-Inverboost-luft-til-vand-varmepumpe-Instalations-Manual.pdf) explains at page 63 that CN10 and CN30 are designed for SG-Ready. These connections I (think) are needed to be connected separately to the relays on the kc868-a8.
Is that right? Do you have any example on how to do that? I think that simple cable without potential will work.
I searched your videos but couldn’t find any information regarding.
Best regards
Savvas
RE: KC868-A8 on Heat Pump for SG-Ready - admin - 05-03-2026
find out the ON/OFF wire control by KC868-A8's relay.