+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-A16 (https://www.kincony.com/forum/forumdisplay.php?fid=25)
+--- Thread: Wiegand (/showthread.php?tid=9479)
Wiegand - williemcvillage - 06-12-2026
Hi, is there a way to use any of the GPIOs of this board to connect a Wiegand reader?
Thanks
RE: Wiegand - admin - 06-13-2026
if you config by ESPHome, you can use wiegand reader.
if you want use KCS firmware, only KCS v3 with KC868-A16v3 PCB support to use wiegand directly.
RE: Wiegand - williemcvillage - 06-13-2026
(06-13-2026, 12:19 AM)admin Wrote: if you config by ESPHome, you can use wiegand reader.
if you want use KCS firmware, only KCS v3 with KC868-A16v3 PCB support to use wiegand directly.
Yes, I would like to use a wiegand reader and esphome with this board. Is this possible?
RE: Wiegand - admin - 06-14-2026
sure, you can use 2 of free gpio define for D0 and D1.