Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KC868-A16 - IP & PORT ?? Important !!!
#1
KC868-A16 - IP & PORT ?? Important !!!

I would like to control my KC868-A16 (V1.6) module using my mobile phone within my local network (without Internet access).
When setting up the "K-Box Smart" (version 2.0.9) software, I’m asked to enter the IP address and PORT XXXX
The module is connected via LAN cable to my Fritz!Box 7530 router.
I was able to find the IP address in the router menu, but I’m not sure which port number I should enter in the app or where to find it.
Could someone please explain:

which port I should use for the KC868-A16, and
whether a port configuration is needed in the Fritz!Box
if I only want to use the system within my local network (without Internet access)?

Thank you very much for your support!

Best regards,
Günter Lehner
Reply
#2
1. do you have downloaded KCS v2 firmware by USB-C cable firstly? after downloaded, you can use kincony scan deivce tool to find the IP.
here is KCS v2 online guide: https://www.kincony.com/esp32-kcsv2-firmware.html
Reply
#3
Thank you very much.

KC868-A16 firmware v2.2.14
I would like to display the status of the digital and analog values on the KBOX Pad.
Unfortunately, I cannot find the software Kincon_SBC.exe as described in the manual.
How can I display the DI and analog status values on a Windows tablet?
Thank you very much.

KC868-A16 firmware v2.2.14
I would like to display the status of the digital and analog values on the KBOX Pad.
Unfortunately, I cannot find the software Kincon_SBC.exe as described in the manual.
How can I display the DI and analog status values on a Windows tablet?
Thank you very much
Reply
#4
Kincon_SBC.exe only use for KC868-COLB controller.
if you are using KC868-A16. you can open your web browser to login KCS monitor webpage.
Reply
#5
I want to diplay the temperatur in the Tablet, as well as the digital Inputs. I can already See this in Monitor.

See this link: KBOX-Pad Ford Windows PC or Windows Tablet 10 Inch.
Reply
#6
i suggest you use home assistant software, so that can monitor on pad.
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)