H32B pro: No IP adress assigned to controller

[kenny H]

when download firmware , H32B Pro will set to default ip 192.168.1.200 ,  so make sure your router and your computer is 192.168.1.x
if you can't change router's ip address, let ethernet cable connect H32B Pro and your computer directly. just make sure they are in same network, so that can use download tool.

Okay this worked, finally!

So what i did was:

- Connect The controller and laptop directly to each other with an Ethernet cable. ( laptop has an ethernet port )
- Laptop was still connected to the internet via wifi (Don't know if that's neccessary )
- Then on laptop (window 11 ) , I went to: Settings => Network and internet => Ethernet. Here You can change IP settings from " automatic " to "manual. Then assigned a available IP adress in range of the H32B pro controller 192.168.1. X . (See picture below )
- After applying these settings => Open " NET_REMOTE_IAP " application => Type in your Laptops IP adress ( the one you manually input ) => Then power up the H32B Pro controller => Then click the " CONNECT " button within the firt 5 seconds of controlelr startup => Then it Said "connected ". 
- After insert the " BIN - file " containing the firmware with pushing " select firmware " => Pres " Load by filpath ". => Firmware got installed succesfully

-Now to acces the controller: I opened "UDP SCAN LIST" tool, It shows the IP of the controller the router assigned to it. ( it was not 192.168.1.200 but 192.168.0.22 )
- Then I connected the H32B pro controller directly to my router again via the ethernet cable.
- Then Typed in the " 192.168.0.22 " ( In my case ). And I got The Blue login screen again and managed to login and control everything again.

I hope this helps annyone struggling again in the future.

Thank you very much Kincony for the patience and help.

[attachment=6318]