02-15-2025, 09:19 PM
I have completed my configuration for the KC868-M16v2 with nearly accurate amp readings.
I followed the route of another forum member and implemented intervals for switching to the different current clamps.
On my wishlist are some toppics, that i havent figured out yet:
1. Interval change of the display topics: Voltages, Output Group Amps, Output Group apparent power and the Ip Address
2. When I look in the debug log, i see the "switch to input channel" from the CTs jumping around while no measurement is active.
3. When the voltage measuremt interval takes place, my sampling on the CTs go down, i didn´t find out how to give the voltage also a interval.
attached
kc868-m16-v21.txt (Size: 24.6 KB / Downloads: 247)
txt file is the yaml but with .txt ending
I followed the route of another forum member and implemented intervals for switching to the different current clamps.
On my wishlist are some toppics, that i havent figured out yet:
1. Interval change of the display topics: Voltages, Output Group Amps, Output Group apparent power and the Ip Address
2. When I look in the debug log, i see the "switch to input channel" from the CTs jumping around while no measurement is active.
3. When the voltage measuremt interval takes place, my sampling on the CTs go down, i didn´t find out how to give the voltage also a interval.
attached
kc868-m16-v21.txt (Size: 24.6 KB / Downloads: 247)
txt file is the yaml but with .txt ending