(02-16-2025, 05:40 AM)admin Wrote: i suggest to use KCS v3 firmware for AG8 contrlller. it's very easy for home assistant. next week will make video tour about AG8.
KCS v3 firmware donwload link: https://www.kincony.com/forum/showthread.php?tid=7628
how to use IR by KCS v3 , online guide: https://www.kincony.com/how-to-use-kcsv3...board.html
Hello!
I forgot to mention in my original post - I also tried the KCSv3 firmware for the AG8. The device behaves the same. I do not see the Wi-Fi Hotspot broadcast, and the device is not connecting to the network (although the Ethernet port has a link/flashing orange light).
To confirm, I have flashed with these settings.
Hello again!
Just wanted to reply back. I was able to locate a stronger power supply, and my product is now working. It appears the other power supply, while it is capable of powering up the ESP32-S3 to Flash, is not powerful enough to run the board in normal boot mode. I located a 12V 1200mA supply, and the product booted up.
I have attached photos of my old supply and new supply, as well as the voltages on the output without load, and with load, on the stronger supply.
Thank you!