05-06-2025, 08:18 AM
Yes, that is correct. I tried to set up a timer with 2 different software versions (v2.2.10 and v2.2.12). There was not action at the specific time when the output should have been switched on. I had it run for more than 24 hours.
To set up the test is very easy. Please try on your side. Unfortunately this key function is not working.
I'd be also happy if there is any trick or additional steps I could do to make it work.
I just set up another test with a timer to switch on an output. As the point in time was reached, nothing happend.
Kind regards.
To set up the test is very easy. Please try on your side. Unfortunately this key function is not working.
I'd be also happy if there is any trick or additional steps I could do to make it work.
I just set up another test with a timer to switch on an output. As the point in time was reached, nothing happend.
Kind regards.