05-08-2025, 05:48 PM
I have a similar panel with 15 circuits on each phase.
1) How can I make best of use of the m30 to manage all 30 circuits with only two phases?
2) for 220v circuits, the breaker will actually attach across both legs. in this case should the each clamp be wired to the chip supporting that leg?
3) what is the implication in accuracy of a clamp is reporting to the chip not supported by that phase?
Thank you
\\Greg
1) How can I make best of use of the m30 to manage all 30 circuits with only two phases?
2) for 220v circuits, the breaker will actually attach across both legs. in this case should the each clamp be wired to the chip supporting that leg?
3) what is the implication in accuracy of a clamp is reporting to the chip not supported by that phase?
Thank you
\\Greg