Smart Home Automation Forum › Technical Support › KC868-A6 v
Troubles UART

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Troubles UART
ksarz Offline
Junior Member
**
Posts: 22
Threads: 2
Joined: Jun 2025
Reputation: 0
#7
06-27-2025, 08:23 AM (This post was last modified: 06-27-2025, 08:33 AM by ksarz.)
Sorry!
1. I was downdoad KCS_KC868_A6_V2.2.14.bin yesterday yet. see ScreenShot above.  But IP not found see abobe !
2. Is there an example of the correct UART& coding and a diagram of the correct placement of the "A" and "B" pins on the board, what is this?
Which pin corresponds to GND for UART?
3. The photo of the board is below.
Thank you,


Attached Files Image(s)
   
Find
Reply


Messages In This Thread
Troubles UART - by ksarz - 06-26-2025, 08:54 AM
RE: Troubles UART - by admin - 06-26-2025, 11:59 PM
RE: Troubles UART - by ksarz - 06-27-2025, 03:58 AM
RE: Troubles UART - by admin - 06-27-2025, 05:13 AM
RE: Troubles UART - by ksarz - 06-27-2025, 05:56 AM
RE: Troubles UART - by admin - 06-27-2025, 08:22 AM
RE: Troubles UART - by ksarz - 06-27-2025, 08:23 AM
RE: Troubles UART - by admin - 06-27-2025, 08:55 AM
RE: Troubles UART - by ksarz - 06-27-2025, 09:32 AM
RE: Troubles UART - by ksarz - 07-02-2025, 10:21 AM
RE: Troubles UART - by ksarz - 06-30-2025, 10:24 AM
RE: Troubles UART - by admin - 06-30-2025, 10:45 AM
RE: Troubles UART - by admin - 07-02-2025, 10:43 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)