Smart Home Automation Forum › Technical Support › News v
kc-868 AK

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
kc-868 AK
Saif Kitany Offline
Member
***
Posts: 93
Threads: 22
Joined: Jul 2023
Reputation: 0
#11
08-04-2025, 07:24 AM
I set this condition in KC-868 AK, the IF is time condition and THEN is protocol1+protocol2+protocol3+protocol4.

The protocols programed to tuggle Relay in H32B:

Protocol1—-> toggle relay 21
Protocol2—-> toggle relay 22
Protocol 3—-> toggle relay 23
Protocol 4——> toggle relay 24


But the problem i faced, is when i run the condition, it just operates the protocols in the first line, which is protocol1+protocol2.

Protocol 3 and 4 are not operating!!!

What i miss in the case?


Attached Files Image(s)
   
Find
Reply


Messages In This Thread
kc-868 AK - by Saif Kitany - 07-25-2025, 09:54 PM
RE: kc-868 AK - by admin - 07-26-2025, 01:20 AM
RE: kc-868 AK - by Saif Kitany - 07-27-2025, 03:52 AM
RE: kc-868 AK - by admin - 07-27-2025, 07:14 AM
RE: kc-868 AK - by Saif Kitany - 08-01-2025, 12:59 PM
RE: kc-868 AK - by Saif Kitany - 07-28-2025, 07:04 PM
RE: kc-868 AK - by admin - 07-28-2025, 11:14 PM
RE: kc-868 AK - by Saif Kitany - 07-29-2025, 02:29 PM
RE: kc-868 AK - by admin - 07-29-2025, 09:57 PM
RE: kc-868 AK - by admin - 08-01-2025, 11:00 PM
RE: kc-868 AK - by Saif Kitany - 08-04-2025, 07:24 AM
RE: kc-868 AK - by admin - 08-04-2025, 07:59 AM
RE: kc-868 AK - by Saif Kitany - 08-04-2025, 08:25 AM
RE: kc-868 AK - by admin - 08-04-2025, 11:00 AM
RE: kc-868 AK - by Saif Kitany - 08-04-2025, 01:00 PM
RE: kc-868 AK - by admin - 08-04-2025, 11:33 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)