KC-868 COLB - I do not see IP adress

[Alois Láska]

here is online guide: https://www.kincony.com/how-to-use-kc868...oller.html

Finally I managed to connect to the COLB. Thank you for the link!
It seems that your products are very interesting and useful, but what I am struggling with is the lack of clear and concise manuals for the given device.
But your replies on the forum are quick and accurate, which compensates for it a little.

I have another questions: 
- On one picture of the COLB I noticed that the input voltage of the AI inputs is only 0–5 V. Therefore, I need to reduce the 0–10 V signal to half – using a standard resistor divider I assume?
- I have KC-868 A4 and KC-868-COLB in the system and I need to measure more temperature points (app 20). Please give me some recomendation from your products how to do it. I thought that it was possible to connect multiple DS18B20 sensors to a single channel, since it is an addressable sensor, but according to your reply this is not possible… 

I apologize for the silly questions, but I am trying to get a deeper understanding of your product portfolio and design philosophy. Normally, we either use pre-configured controllers, and for more complex systems we rely on standard PLCs.  

thank you