10-22-2025, 09:22 AM
Hello,
I’m trying to connect a 10 kΩ NTC temperature sensor to my KC868-A16 board.
Unfortunately, I don’t get any readings at all.
Which GPIO pins are actually used for the analog inputs?
I used the example code from this forum, but I don’t get any plausible values on any pin.
I also tested by connecting each pin to GND to rule out a sensor issue, but the readings still don’t change.
I’m stuck now — what is the correct code to read the analog inputs properly?
Thanks in advance for your help!
I’m trying to connect a 10 kΩ NTC temperature sensor to my KC868-A16 board.
Unfortunately, I don’t get any readings at all.
Which GPIO pins are actually used for the analog inputs?
I used the example code from this forum, but I don’t get any plausible values on any pin.
I also tested by connecting each pin to GND to rule out a sensor issue, but the readings still don’t change.
I’m stuck now — what is the correct code to read the analog inputs properly?
Thanks in advance for your help!