Hi,
I didn't found any manual for this board, but the A8 has one here in the forum.
https://www.kincony.com/forum/showthread.php?tid=7164
I have adapted it for using it with the A2 board. So if anyone searches this info, just follow the steps in the A8 posting, but instead add the following to your /homeassistand/configuration.yaml file.
Just replace the ID 99999648C3D98 with your board serial number, shown under "Index" in the WebGUI of the KCS software.
I just added the relay-switches, I don't know if there are any more possibilities linke binary sensors or anything. If yes, I think the code from the A8 can be easily adapted.
It worked fine for me.
Regards
I didn't found any manual for this board, but the A8 has one here in the forum.
https://www.kincony.com/forum/showthread.php?tid=7164
I have adapted it for using it with the A2 board. So if anyone searches this info, just follow the steps in the A8 posting, but instead add the following to your /homeassistand/configuration.yaml file.
Code:
switch:
- name: 'a2-kcs-output-1'
unique_id: a2-kcs-output-1
state_topic: 'KC868_A2/99999648C3D98/STATE'
command_topic: 'KC868_A2/99999648C3D98/SET'
payload_on: '{"output1":{"value":true}}'
payload_off: '{"output1":{"value":false}}'
value_template: '{{ value_json.output1.value }}'
state_on: true
state_off: false
- name: 'a2-kcs-output-2'
unique_id: a2-kcs-output-2
state_topic: 'KC868_A2/99999648C3D98/STATE'
command_topic: 'KC868_A2/99999648C3D98/SET'
payload_on: '{"output2":{"value":true}}'
payload_off: '{"output2":{"value":false}}'
value_template: '{{ value_json.output2.value }}'
state_on: true
state_off: falseJust replace the ID 99999648C3D98 with your board serial number, shown under "Index" in the WebGUI of the KCS software.
I just added the relay-switches, I don't know if there are any more possibilities linke binary sensors or anything. If yes, I think the code from the A8 can be easily adapted.
It worked fine for me.
Regards