(11-20-2025, 11:16 PM)admin Wrote: when A16v3 digtal input short with GND = sensor ON. so make sure your device logical by this way. Maybe you can change your COM, NO, NC port signal for A16v3.
Hello, Thanks for replay
I think there are visible in a16v3 as switch. But via ESP Home there are configured as binary_sensor. As on the photo is door sensor and motion sensor should work ?
1. But state should change when I bring the magnet closer to the read switch. But nothing changed. Wrong configuration? Wrong reed switch?
when A16v3 digtal input short with GND = sensor ON. so make sure your device logical by this way. What I can change?
2. Same with motion sensor. State only change when I push "tamper switch". There is no state change when sensor see the motion.
Maybe you can change your COM, NO, NC port signal for A16v3. How to do that?