12-03-2025, 08:29 PM
(This post was last modified: 12-03-2025, 08:35 PM by Alois Láska.)
(11-25-2025, 11:22 PM)admin Wrote: just connect COLB to router by ethernet cable, then try to login by 192.168.1.200 or you can use kincony scan device tool to find the ip address.
thanks it works but my IP scanner does not show the name of new device and I did not realized an add new device with new IP address...
I have another trouble with COLB, trying to solve it with all my knowladge and Chatgpt too :-).
I have 5 temperature sensor connected to the COLB Dallas DS18B20. Connected trough calm family house (no industry), connected with UTP cable CAT5 app 15-20m lenght. I sorted out that data and GND is conected with twisted pair green and greenwhite. Power supply is connected with orange and I used also orangewhite for GND too.
But still channel 1 and 3 does not want to communicate with sensor.
When I connect sensor 1 or 3 to the channel 2, it si sucesffuly meassured.
When I connect sort just sensor to the channel 1 or 3 it is aslo measured.
What is diffrence between 1 and 3 channel? Please any advice? I am preparing aslo to add some capacitor between VCC and Data acording some advice... But may be you will have some feedback what to do...
Thanks