T16M not responding on USB

[robarends]

Hello,

I have 2 T16M.

I am building a Wiegand door lock controller with ESPHome firmware, and am proceeding well.

I am currently using my second T16M with a Wiegand S20 keypad via a 5v - 3v3 logic level shifter.


However when I was using the first T16M, I did not use the 5v - 3v3 logic level shifter.
After some time of development using ESPhome it stopped responding via USB.
I had assumed I damaged the T16M.

You have advised that "you can connect Wiegand D0 and D1 to T16M free GPIOs directly, not need logic convert.", so therefore my assumption was incorrect.

I have seen in another thread that you can reset the T16M using the DW button while power-on.

Using that method has not made the USB work.

What can I do to make the USB work again?

Thanks, Rob.