01-24-2026, 04:13 AM
I see two 5.1 Ohm burden (bias) resistors are built in to the input circuit
https://www.kincony.com/forum/showthread.php?tid=8612
Does it matter if I select voltage ouput, or current output CT clamps? i.e. do the 5.1ohm resistors need to be cut if I use a voltage output CT clamp?
Is there a calibration routine? I will be using ESPHome.
Maybe there is a user manual for Nx that explains this?
Thank you
https://www.kincony.com/forum/showthread.php?tid=8612
Does it matter if I select voltage ouput, or current output CT clamps? i.e. do the 5.1ohm resistors need to be cut if I use a voltage output CT clamp?
Is there a calibration routine? I will be using ESPHome.
Maybe there is a user manual for Nx that explains this?
Thank you