02-04-2026, 06:42 AM
Thank you for your reply, but it doesn't help me achieve my goal.
I would appreciate your assistance. On the KC868-HA-V2, I have set Target Relay: Address: 1. On the main board: KC868-A16V3 (KCS v3.18.0 firmware), I have also set Switch Adapter Address: 1. RS485: enable, protocol: MODBUS-HA, local address: 1
When I activate input IN:1 on HA-V2, output OUT: 1 on the KC868-A16V3 is set. The same behavior occurs for IN:2 → OUT:2...
Is the addressing correct here?
Furthermore, I cannot see any I/O status in Home Assistant. Do I need to change something/adjust the YAML settings? If so, what?
I have already watched many videos and read tips from chatgpt...
I would appreciate your assistance. On the KC868-HA-V2, I have set Target Relay: Address: 1. On the main board: KC868-A16V3 (KCS v3.18.0 firmware), I have also set Switch Adapter Address: 1. RS485: enable, protocol: MODBUS-HA, local address: 1
When I activate input IN:1 on HA-V2, output OUT: 1 on the KC868-A16V3 is set. The same behavior occurs for IN:2 → OUT:2...
Is the addressing correct here?
Furthermore, I cannot see any I/O status in Home Assistant. Do I need to change something/adjust the YAML settings? If so, what?
I have already watched many videos and read tips from chatgpt...