02-08-2026, 07:27 PM
Hi all,
i have some B16 currently with the 3.80 kcs firmware.
I had the need to control an output on the module 2 when a DI on module 1 is pressed.
I saw i can do it with custom protocol. I tried with UDP message, but it seems a bit loosy, in some ways each 10 clicks, 2 or 3 are lost, alternatively i thought i could do it with http call (POST or GET).
The problem is that i don't know how to do it with the KCS firmware, i don't know if there are some preconfigured urls to let the modules relays to be switched on off or toggled.
I saw on ESPHome there are some documentations talking about this possibility, but i'm not sure these are usable on KCS firmware.
Sorry i'm a bit new and i cannot find a way to do this, but i'm pretty sure it can be done easily, and i'm just not able to do it.
Could someone please help me?
i have some B16 currently with the 3.80 kcs firmware.
I had the need to control an output on the module 2 when a DI on module 1 is pressed.
I saw i can do it with custom protocol. I tried with UDP message, but it seems a bit loosy, in some ways each 10 clicks, 2 or 3 are lost, alternatively i thought i could do it with http call (POST or GET).
The problem is that i don't know how to do it with the KCS firmware, i don't know if there are some preconfigured urls to let the modules relays to be switched on off or toggled.
I saw on ESPHome there are some documentations talking about this possibility, but i'm not sure these are usable on KCS firmware.
Sorry i'm a bit new and i cannot find a way to do this, but i'm pretty sure it can be done easily, and i'm just not able to do it.
Could someone please help me?