02-21-2026, 11:57 PM
Hi,
I have just received my T32M device and started assembly. I noticed that Output 1 is directly connected to DC+, turning on/off the output doesn't stop the circuit, it's always on.
I have recorded a short video to demo. Can you please advise if there is something special about output 1 or if there is a fault? All other outputs from 2 to 32 are ok, can turn them on and off.
T32M Output 1 problem
I have just received my T32M device and started assembly. I noticed that Output 1 is directly connected to DC+, turning on/off the output doesn't stop the circuit, it's always on.
I have recorded a short video to demo. Can you please advise if there is something special about output 1 or if there is a fault? All other outputs from 2 to 32 are ok, can turn them on and off.
T32M Output 1 problem