I2c Scan and Sensor Page Help

[RichCNY]

I'm trying to hook up an SHT30 sensor to the I2c connector and from what I'm reading the default address is 0x44 (or 0x45) but I'm not getting an readings on the monitor page when set that way (after I add it in the sensor page). Is there any way to scan the I2c bus within KCS V3 so determine the address for certain ?

Also I assume the sensor address on the sensor page its looking for the last 2 numbers of the address as 0x44 does it save correctly, its wiped out after save, but I can type 44 and save without issues ?

Thanks in advance for any assistance,
Rich