KC868-A16 ethernet work with home assistant by ESPHome configure

[Elgatoguiri]

yes, it's right.

So, I'm about to replace the wifi section of the KC868-A16 to this:

Code:

ethernet:
  type: LAN8720
  mdc_pin: GPIO23
  mdio_pin: GPIO18
  clk_mode: GPIO17_OUT
  phy_addr: 0

But chatgpt is arguing that it isn't the correct configuration for the board. It says I should use this config:

Code:

ethernet:
  type: LAN8720
  mdc_pin: GPIO23
  mdio_pin: GPIO18
  clk_mode: GPIO0_IN
  phy_addr: 1
  power_pin: GPIO5