kWh resolution

[Painy]

When you make the video, could you make it into a real life scenario tutorial?
I've made two mistakes when installing the n30 that could have been avoided with better instructions.

1. How to measure voltage. I used a CT clamp first, which does not work of course. You suggested using the two terminals of a power plug cable in an outlet and hook that up to the n30. That was not possible for me because the N30 is in my distribution box. Instead, I put two extra wires (neutral and live) behind three of the fuses in the distribution box and connected them to V1-V3. That also worked.
   
   
2. I have a 3x230V system without a neutral. The three voltages are split over all my two fase fuses. So 1/3 of my fuses use the first voltage (V1), 1/3 uses V2 and 1/3 uses V3. At first i had just randomly connected the CT clamps to the 1-30 terminals. After seeing that some power readings were al wrong, I concluded that I had to connect all fuses connected to the first voltage of my distribution box to N30 V1: 1-10 connections. Same with V2 and V3. Like I said, lost a lot of time with that
   

Maybe write down how different distribution box types can be used? Like a one phase system is easy, but can you wire a 3x230V + 1N to the N30?
The documentation on the website is lacking about hardware configuration. It's mainly about software.

Thank you
 [/list]