(Yesterday, 12:53 AM)admin Wrote: ok, will update in future version.
Great, thank you!
I do have another question if I may. The power factor showing is this an aggregate power factor for the whole set of 10 channels?
I am wondering if it would be possible to see the power factor being measured for each of the individual 10 channels separately. I am assuming the chip used to measure voltage and current is able to determine the power factor on each channel. Once current factor is properly compensated during calibration then the rest would be just math to determine the Watts and Energy values which could be done in software. There would need to be selection for 3 phase panels to allow for different formula when calculating Watts and Energy.
Just food for thought. I find little cumbersome to calibrate the device for each of the channels. Also if power factor changes due to the load type then calibration would be off when these coefficients are hard set .
Thank you for excellent support on your product!!!!!