Smart Home Automation Forum › Technical Support › N60
N60 Sensor channel label

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
N60 Sensor channel label
marekd1 Offline
Junior Member
**
Posts: 8
Threads: 1
Joined: Apr 2026
Reputation: 0
#13
Yesterday, 12:29 AM (This post was last modified: Yesterday, 01:32 AM by marekd1.)
(Yesterday, 12:09 AM)admin Wrote: 1: the "power factor" according to channel1. BL0910 chip only have one channel power factor, can't monitor 10 channels.

Ok, thank you for checking.

Can you tell me if there is a procedure to properly calibrate  the measurements on each of the channels?
Find
Reply


Messages In This Thread
N60 Sensor channel label - by marekd1 - 04-14-2026, 02:44 PM
RE: N60 Sensor channel label - by admin - 04-14-2026, 09:41 PM
RE: N60 Sensor channel label - by marekd1 - 04-16-2026, 04:00 PM
RE: N60 Sensor channel label - by admin - 04-17-2026, 05:50 AM
RE: N60 Sensor channel label - by marekd1 - 04-17-2026, 12:07 PM
RE: N60 Sensor channel label - by admin - 04-17-2026, 02:31 PM
RE: N60 Sensor channel label - by marekd1 - 04-17-2026, 07:03 PM
RE: N60 Sensor channel label - by admin - 04-18-2026, 12:53 AM
RE: N60 Sensor channel label - by marekd1 - 04-18-2026, 03:59 PM
RE: N60 Sensor channel label - by admin - 04-19-2026, 04:05 AM
RE: N60 Sensor channel label - by marekd1 - 04-19-2026, 02:05 PM
RE: N60 Sensor channel label - by admin - Yesterday, 12:09 AM
RE: N60 Sensor channel label - by marekd1 - Yesterday, 12:29 AM
RE: N60 Sensor channel label - by admin - Yesterday, 02:26 AM
RE: N60 Sensor channel label - by marekd1 - Yesterday, 11:50 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)