Current and Power not adding up for some sensors

[edalquist]

I believe these are from KinCony.

I used a clamp-around multimeter to spot check circuits. The amp measurement in the KinCony software webui was always pretty close, so it seems to be some sort of issue with the Watts calculation.

I also noticed that the power factor for the various connections is all over the place if you take a look at monitor.pdf

I'm in the US with split-phase power, my wiring is:
- Monitor 1: Phase A Solar Inverter
- Monitor 4: Phase B Solar Inverter
- Monitor 2 & 3: Phase A External Power
- Monitor 5 & 6: Phase B External Power