Yesterday, 01:42 AM
I use a Board KC868-A16 Rev1.6.3 with tasmota firmware-en-a16.bin from here. After installation I have two ip-addresses (via dhcp) one for wifi and one for ethernet.
In the console I can change the wifi adress to a static address with the command ipaddress1 xxx.xxx.xxx.xxx , that works fine.
But how can I change the ethernet-address to a static one?
In the console I can change the wifi adress to a static address with the command ipaddress1 xxx.xxx.xxx.xxx , that works fine.
But how can I change the ethernet-address to a static one?