Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KC868-HAv2: TS sensor on HAv2 bus, temp/humidity at panel, source code
#5
Thank you for the clear answers, that helps a lot.

So a lost press is not repeated and the HAv2 does not wait for an idle bus. Collisions can only be avoided on the
controller side, which is what we do: the F24 polls the TS only when the bus has been quiet, never within 10 s of a
button frame, and tries up to 3 times. Good to know that foreign frames do not disturb the HAv2 itself.

Update from our bench: 18 hours with the TS polled every 10 s on the HAv2 bus, using the patched kc868_ha.
6,438 polls, 6,436 replies (one retry, one poll in flight when we read), 0 failed cycles, no reboot. In production
we will poll only every 90 minutes.

The code change is here as a pull request: https://github.com/hzkincony/esphome-kc868-ha/pull/3

Thanks again.
Reply


Messages In This Thread
RE: KC868-HAv2: TS sensor on HAv2 bus, temp/humidity at panel, source code - by swisstmack25 - Yesterday, 07:00 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)