KC868-A8s uploading errors

[Auxinne Paul]

C:\>python -m esptool --chip esp32 --port COM5 write_flash_status --non-volatile 0
esptool.py v4.4
Serial port COM5
Connecting.....
Chip is ESP32-D0WD-V3 (revision v3.0)
Features: WiFi, BT, Dual Core, 240MHz, VRef calibration in efuse, Coding Scheme None
Crystal is 40MHz
MAC: c4:de:e2:ce:cc:60
Uploading stub...
Running stub...
Stub running...
Initial flash status: 0x0200
Setting flash status: 0x0000
After flash status: 0x0200
Hard resetting via RTS pin...

---

I did all that but still it doesnt work

---

C:\Users>python -m esptool --chip esp32 --port COM5 --baud 115200 --after hard_reset erase_flash
esptool.py v4.4
Serial port COM5
Connecting.....
Chip is ESP32-D0WD-V3 (revision v3.0)
Features: WiFi, BT, Dual Core, 240MHz, VRef calibration in efuse, Coding Scheme None
Crystal is 40MHz
MAC: c4:de:e2:ce:cc:60
Uploading stub...
Running stub...
Stub running...
Erasing flash (this may take a while)...
Chip erase completed successfully in 0.0s
Hard resetting via RTS pin...

---

Initial flash status: 0x0200
Setting flash status: 0x0000
After flash status: 0x0200
Hard resetting via RTS pin...

I think the problem is that the initial flash status is 0x0200 and after trying to set it to 0x0000 it still remains on 0x0200 as indicated above