E16V3 - No reply if command issued just after another command to another device on th

[ldebacker]

Hello,

I have 2 E16V3 installed as 2 different slaves on the same modbus.

When I send a command to each in isolation, I  receive a response within a few milli-seconds from the E16V3.

But when I send a command to the second E16V3 immediately after successful response from the first one, then I never receive the response from the second device.

It seems that the second E16V3 is puzzled by the activity on the bus that is not intended to himself.

I have to retry the command to the second E16V3, or wait (20 miliseconds for example) before sending the command to the second E16V3

I can help troubleshooting further if needed.

BRs,

Laurent