KC868-A16 rev1.6 firmware

[maurus44]

Hello,
I am using a KC868-A16 board (REV: 1.6) and I would like to confirm which firmware is correct for this device.
I have been flashing firmware using the ESP32 Flash Download Tool (v3.9.2). So far, I have tested the following firmware versions:

• KCS_A16V3_V3.24.3 → I was not able to access the controller after flashing
  
• KCS_KC868_A16_V2.2.4 → I could access the controller, but the input table was incomplete / partially missing
  

At the moment, I am using:

• KC868_A16_V1.0.10 → this version works, and I can access the controller
  

My question is:
Am I using the correct firmware for KC868-A16 REV: 1.6, or is there a newer recommended version that is fully compatible?
Thank you in advance for your help!

[admin]

your board A16 , only use by KCS v2 firmware, KCS v3 firmware use for A16v3 board , that use for ESP32S3 module.
here is newest firmware for your board: https://www.kincony.com/forum/showthread.php?tid=9205

[maurus44]

Hello,
Thank you for your help.
I followed your instructions and used the ESP32 Flash Download Tool (v3.9.2) with the following settings:

• chipType: ESP32
  
• workMode: develop
  

I downloaded and flashed the firmware:

• KCS_KC868_A16_V2.2.20
  

Before flashing, I clicked "Erase", and then "Start". After that, I power-cycled the board.
A new Wi-Fi network appeared, and I connected to it. I opened:
http://192.168.4.1/input_setting.htm
I logged in using the default credentials (admin).
However, when I go to the "Input" tab, I see fewer configuration options compared to what is shown in the tutorial video.
My question is:
Did I make a mistake somewhere, or is this normal behavior for this firmware version? I added some pictures.
Thank you in advance for your support.

[admin]

it's correct. because KCS v2 use by IFTTT. you config digital input with OUTPUT by IFTTT webpage.
you can see KCS v2 online guide firstly: https://www.kincony.com/esp32-kcsv2-firmware.html