Hello everyone,
I’m using a Kincony M30 to monitor individual group energy consumption, but I’ve noticed that the kWh readings are reported in 1 kWh increments.
Is there a way to configure the M30 (or its firmware) so that it reports energy in 0.01 kWh steps instead of whole kWh?
Any guidance or configuration tips would be greatly appreciated.
Thank you!
I’m using a Kincony M30 to monitor individual group energy consumption, but I’ve noticed that the kWh readings are reported in 1 kWh increments.
Is there a way to configure the M30 (or its firmware) so that it reports energy in 0.01 kWh steps instead of whole kWh?
Any guidance or configuration tips would be greatly appreciated.
Thank you!