+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-M16 / M1 / MB / M30 (https://www.kincony.com/forum/forumdisplay.php?fid=50)
+--- Thread: KC868-M16v2 configure yaml for ESPhome (/showthread.php?tid=3088)
RE: KC868-M16v2 configure yaml for ESPhome - cmeyer5 - 12-19-2025
(10-19-2025, 10:34 AM)admin Wrote: you can re download firmware. Or edit from home assistant for calibration.
hi
i bought a m16v2.1 and loaded into HA via esphome. however the input sensors dont show. i only see the firmware sensor as in the image. where might the issue be.
RE: KC868-M16v2 configure yaml for ESPhome - cmeyer5 - 12-19-2025
(10-19-2025, 10:34 AM)admin Wrote: you can re download firmware. Or edit from home assistant for calibration.
hi,
managed to get M16v2 integrated into HA via esphome. the route I followed was to do the initial setup in esphome, and then selected the install option. all went ok. the device was then discoverable by HA. When i look at it in HA it doesn't have the input sensors. see attached image. what is missing?
some information
RE: KC868-M16v2 configure yaml for ESPhome - admin - 12-19-2025
just use our yaml file directly.
RE: KC868-M16v2 configure yaml for ESPhome - cmeyer5 - 12-21-2025
(12-19-2025, 01:53 PM)admin Wrote: just use our yaml file directly.
thanks.
used to yaml file but am getting a custom error in esphome builder.
RE: KC868-M16v2 configure yaml for ESPhome - admin - 12-21-2025
use this yaml: https://www.kincony.com/forum/attachment.php?aid=8221