+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: DIY Project (https://www.kincony.com/forum/forumdisplay.php?fid=3)
+--- Thread: Why DC 12 volt coil for kinCony system? (/showthread.php?tid=1112)
Pages:
1
2
RE: Why DC 12 volt coil for kinCony system? - admin - 11-12-2021
see this video , you will understand easily.
RE: Why DC 12 volt coil for kinCony system? - ahmed - 11-12-2021
Thanks for last video
As i understood we had 32 terminal blocks input can have bridges if i would like to have a group of one input or separate e2 input to 32 output as a second raw in the terminal block am i correct?
Do you have from HC686-H32B less channel 16B and 8B for the same controller function?
RE: Why DC 12 volt coil for kinCony system? - ahmed - 11-12-2021
Back to the maximum current suggest every channel not >3A to use
If the load is 6 A for example can i use 2 input and 2 channel output switch on/ off together to carry the load 6 Amp ? Is it possible ?
RE: Why DC 12 volt coil for kinCony system? - admin - 11-13-2021
switch termoa board , input1 -> output1, input2->output2 .....
if you want input1 customsize link with outputX, you need add KC868-COLB logical controller, that can do your logical set for input trigger output.
yes, H32B,H16B,H8B,H4B,H2B different output version relay controller you can chose.
RE: Why DC 12 volt coil for kinCony system? - admin - 11-13-2021
(11-12-2021, 10:48 PM)ahmed Wrote: Back to the maximum current suggest every channel not >3A to use
If the load is 6 A for example can i use 2 input and 2 channel output switch on/ off together to carry the load 6 Amp ? Is it possible ?
no, not suggest use by this way. if large current, just add extend relay or contactor.