+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-Uair (https://www.kincony.com/forum/forumdisplay.php?fid=31)
+--- Thread: K868-Uair proper GPIO assignation ? (/showthread.php?tid=1740)
Pages:
1
2
RE: K868-Uair proper GPIO assignation ? - vincen - 03-14-2022
(03-13-2022, 01:37 AM)admin Wrote: i think you need to check software, hardware is no problem, here is some our demo images.
Did you get a look at code I use ? You'll see it's good and it's clearly device that has a wiring problem on board !!
RE: K868-Uair proper GPIO assignation ? - admin - 03-14-2022
your code have problem, i already told you the reason and give you the correct code, just use it!
RE: K868-Uair proper GPIO assignation ? - admin - 03-14-2022
GPIO33 use for 1 LED !!!
GPIO32 use for 4 LED
you have define all is "4"! Do you understand?
RE: K868-Uair proper GPIO assignation ? - vincen - 03-15-2022
(03-14-2022, 11:19 AM)admin Wrote: GPIO33 use for 1 LED !!!
GPIO32 use for 4 LED
you have define all is "4"! Do you understand?
Yep but it doesn't change the problem as it's a bad layout problem in device itself !! When the bar is on one of the ring led doesn't follow anymore the ring !! Default of product design, sorry to say
