+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-E16S/E16P (https://www.kincony.com/forum/forumdisplay.php?fid=26)
+--- Thread: [Arduino IDE of KC868-E16S]--#00-KC868-E16S-configure for ESPhome (/showthread.php?tid=1921)
Pages:
1
2
RE: [Arduino IDE of KC868-E16S]--#00-KC868-E16S-configure for ESPhome - asantos - 08-10-2022
I'm testing the KC868-E16S board and even after installing the image generated by ESPHome using the template provided in the tutorial on this site, whenever I turn off the power and turn it on again, the board comes back with relays 1,2,3,4,5,6, 7, 8 and 9 turned on irrespective of the state they were in before the power cut.
How do I get them to always come back off when restarting?
RE: [Arduino IDE of KC868-E16S]--#00-KC868-E16S-configure for ESPhome - admin - 08-10-2022
post your config file at here, you'd better upload a video of your question.
RE: [Arduino IDE of KC868-E16S]--#00-KC868-E16S-configure for ESPhome - peca2345 - 04-04-2023
Hello, everything works fine via esphome, but I don't know how to set up modbus communication.
Can you please write me the configuration ?
Thank you very much!
RE: [Arduino IDE of KC868-E16S]--#00-KC868-E16S-configure for ESPhome - admin - 04-05-2023
here is our video tour of ESPHome modbus controller: