Smart Home Automation Forum
KC868-H32B V4.29 new firmware update - Printable Version

+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: News (https://www.kincony.com/forum/forumdisplay.php?fid=5)
+--- Thread: KC868-H32B V4.29 new firmware update (/showthread.php?tid=276)

Pages: 1 2


RE: KC868-H32B V4.29 new firmware update - uvrtar - 06-02-2021

Hi,

I also get wrong username and password error, when I try to update firmware on 4.29. Bootloader and everything went ok, I get the web page of the controller (admin/admin does not work), also all the switch terminal board inputs work.
Also I noticed when I try to switch the relays with my previeos configuration in Node-Red, that the controller is very slow, and responds to commands with a delay or does not respond at all.

With 4.20 fw all worked ok. Every week or so I had to reset the controller, because it did not respond on my commands - switch terminal board commands and HA(node red) commands.


RE: KC868-H32B V4.29 new firmware update - admin - 06-03-2021

if you updated newest firmware, we suggest integrate to HA with MQTT, it's very stable, not need to use Node-Red work with HA. only HA is enough.


RE: KC868-H32B V4.29 new firmware update - uvrtar - 06-03-2021

I will do that.

But what about the password error and about the controller not responding?

thank you.


RE: KC868-H32B V4.29 new firmware update - admin - 06-03-2021

after update to newest verison, user name and password all default set to "admin" , "admin".


RE: KC868-H32B V4.29 new firmware update - uvrtar - 06-03-2021

[Image: wCznWqm]

After update to 4.29


RE: KC868-H32B V4.29 new firmware update - mirko - 06-03-2021

In my case didn't work admin/admin also after an update. I had to reset to default settings.


RE: KC868-H32B V4.29 new firmware update - admin - 06-03-2021

new firmware use ethernet button for reset will set user name and password to "admin" - "admin"


RE: KC868-H32B V4.29 new firmware update - uvrtar - 06-04-2021

Ok, thank you.

What is the correct procedure for reset, and could you point me to the correct button for the reset.

Thank you.


RE: KC868-H32B V4.29 new firmware update - admin - 06-05-2021

Hold on "Ethernet Mode" button, when the [yellow and white LED] all is ON, release it, then work mode in “UDP” and IP by DHCP mode and password reset to "admin". user name fixed by "admin", never changed.


RE: KC868-H32B V4.29 new firmware update - uvrtar - 06-05-2021

OK, now after reset it is working.
Thank you.