+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: DIY Project (https://www.kincony.com/forum/forumdisplay.php?fid=3)
+--- Thread: Smart Home project (/showthread.php?tid=3163)
Pages:
1
2
RE: Smart Home project - arksop - 10-31-2024
(10-30-2024, 11:28 PM)admin Wrote: 1. this is KCS firmware for KC868-A64: https://www.kincony.com/forum/showthread.php?tid=3504
Do you download this version?
2. you can also config by ESPHome for your KC868-A64
3. can you draw a diagram on paper, how you connect KC868-A64 with KC868-E16v2 board.
1. Yes i used this version.
2. yes we know, it will be done later.
3. below
on picture you have only 2 E16v2
next 2 E16v2 is conected the same and powered by second power supply the same way.
RE: Smart Home project - admin - 10-31-2024
if you use two power supply, you should connect two power supply's GROUND together. why not use one big current power supply? such as DC12V 7A
RE: Smart Home project - arksop - 10-31-2024
(10-31-2024, 01:48 PM)admin Wrote: if you use two power supply, you should connect two power supply's GROUND together. why not use one big current power supply? such as DC12V 7A
Yes i think it will resolve this issue
How much power I should delivery for a64 + 4 e16?
4x 16 x 0,5w =32 W
A64 20 w
60 w?
Why you propose 100w ? In our previous conversation I asked about power supply and you said that it’s ok to power it up like this. If one bigger will be better I will change .
but still it’s super slow and sometime not refreshing the status ?
(10-31-2024, 01:48 PM)admin Wrote: if you use two power supply, you should connect two power supply's GROUND together. why not use one big current power supply? such as DC12V 7A
Yes i think it will resolve this issue
How much power I should delivery for a64 + 4 e16?
4x 16 x 0,5w =32 W
A64 20 w
60 w?
Why you propose 150w ? In our previous conversation I asked about power supply and you said that it’s ok to power it up like this. If one bigger will be better I will change .
but still it’s super slow and sometime not refreshing the status ?
RE: Smart Home project - admin - 10-31-2024
because of all relay ALL ON at the same time, instantaneous current is very high. But now just connect your two power supply GROUND together for testing firstly.