Add uptime to board information

Add uptime to board information - Printable Version

+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: Suggestions and feedback on KinCony's products (https://www.kincony.com/forum/forumdisplay.php?fid=39)
+--- Thread: Add uptime to board information (/showthread.php?tid=9288)

Pages: 1 2

RE: Add uptime to board information - admin - 05-16-2026

this is new version, you can test, you asked the point-3 :

new version improvement:

1. Daylight saving time adaptation (add DST configuration to firmware system + IFTTT automatic adjustment to new time)
2. Multi-channel configuration support for the Wiegand protocol
3. Display cumulative online duration on the web page (web + MQTT + HA)
4. Support for third-party sensor integration using the standard Modbus protocol
5. add send IR signal to ALL GPIO channels
6. add mqtt "force update" option for home assistant

.zip

KCS_A16V3_V3.25.0_beta_20260516-015245.zip (Size: 1.16 MB / Downloads: 48)

RE: Add uptime to board information - twostar - 05-16-2026

Nice, thanks! I'll try and get it tested tomorrow, it's in a slightly inaccessible location :-).

RE: Add uptime to board information - admin - 05-16-2026

here are photo.

Filename: uptime.png Size: 47.84 KB 05-16-2026, 05:04 AM

Filename: wiegand-multi.png Size: 94.14 KB 05-16-2026, 05:04 AM

Filename: HA-mqtt-force-update.png Size: 65.01 KB 05-16-2026, 05:04 AM

Filename: modbus-sensor.png Size: 81.12 KB 05-16-2026, 05:04 AM

Filename: DST.png Size: 62.41 KB 05-16-2026, 05:04 AM

RE: Add uptime to board information - twostar - 05-17-2026

Just reflashed and tested, everything's working fine, thanks for adding this! It's also nice that the uptime display is live, so it updates without having to refresh the page.

RE: Add uptime to board information - admin - 05-17-2026

ok, good.