+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: Home automation training courses (https://www.kincony.com/forum/forumdisplay.php?fid=18)
+--- Thread: Lesson11 - how to use by own 433MHz RF / infrared remoter (/showthread.php?tid=1797)
RE: Lesson11 - how to use by own 433MHz RF / infrared remoter - admin - 10-13-2025
sure, it's ok. just set by IFTTT, let IR toggle Relay.
RE: Lesson11 - how to use by own 433MHz RF / infrared remoter - beemasport - 10-14-2025
(10-13-2025, 09:52 PM)admin Wrote: sure, it's ok. just set by IFTTT, let IR toggle Relay.
Can you please explain? - I was able to start the complete project just few days ago, and i am really still learning.
I am following the tutorial of lesson 11, but the 433mhz switches show no id but some weird symbols and they are not the same every time.
Using home assistant.
Again many thanks in advance!
RE: Lesson11 - how to use by own 433MHz RF / infrared remoter - admin - 10-14-2025
this is KCS v3 online guide: https://www.kincony.com/how-to-use-kcsv3-firmware-esp32-board.html
RE: Lesson11 - how to use by own 433MHz RF / infrared remoter - beemasport - 10-14-2025
(10-14-2025, 07:28 AM)admin Wrote: this is KCS v3 online guide: https://www.kincony.com/how-to-use-kcsv3-firmware-esp32-board.html
My controller is KC868-Server.
RE: Lesson11 - how to use by own 433MHz RF / infrared remoter - admin - 10-14-2025
ok, you can config by esphome to learn RF signal. Because of KC868-Server RF manager by ESP32.