KC868-D8 V4.36 new firmware update - Printable Version +- Smart Home Automation Forum (https://www.kincony.com/forum) +-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1) +--- Forum: News (https://www.kincony.com/forum/forumdisplay.php?fid=5) +--- Thread: KC868-D8 V4.36 new firmware update (/showthread.php?tid=1492)

KC868-D8 V4.36 new firmware update - admin - 12-23-2021 improvement: support send MQTT command control multi output by one command: such as if you want to let KC868-D8 dimmer output1:50% output2:60% output3:70% you can send: {"dimmer1":{"value":50},"dimmer2":{"value":60},"dimmer3":{"value":70}}     update BIN file firmware by "KC868 Controller Network Bootloader" tool. firmware BIN file   Dimmer8_V436_1222.zip (Size: 47.25 KB / Downloads: 272) RE: KC868-D8 V4.36 new firmware update - hentes - 12-29-2021 When pressing "Step 1-Connect" every time I get an error "Please check network". Computer and board are on the same network, pressing "Step 1-Connect" is 2-4 seconds after powering on the board. Where is the error? I've tried about 60 times without success. Thank you for your help. RE: KC868-D8 V4.36 new firmware update - admin - 12-30-2021 do you have set the local IP with your computer's IP address? RE: KC868-D8 V4.36 new firmware update - admin - 12-30-2021 do you have update your firmware firstly? see details in this topic: https://www.kincony.com/forum/showthread.php?tid=808 RE: KC868-D8 V4.36 new firmware update - hentes - 03-29-2022 Same "Please check network" error when trying to update firmware to COLB. Computer and COLB on same network, IP of computer is correct and pressed the "Connect" button before the 5sec limit. RE: KC868-D8 V4.36 new firmware update - admin - 03-29-2022 download firmware network tool only support by KC868-D8 dimmer controller and KC868-Server. KC868-COLB download by USB-RS232 cable , use RS232 download tool.