[arduino source code for KC868-Uair-7] send IR code signal - Printable Version +- Smart Home Automation Forum (https://www.kincony.com/forum) +-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20) +--- Forum: KC868-Uair (https://www.kincony.com/forum/forumdisplay.php?fid=31) +--- Thread: [arduino source code for KC868-Uair-7] send IR code signal (/showthread.php?tid=1576)

[arduino source code for KC868-Uair-7] send IR code signal - admin - 01-03-2022 #include "PinDefinitionsAndMore.h" #include <IRremote.h> void setup() {   Serial.begin(9600);   IrSender.begin(IR_SEND_PIN, ENABLE_LED_FEEDBACK); }   uint16_t sAddress = 0x78;   uint8_t sCommand = 0xCD;   uint8_t sRepeats = 0; void loop() {   IrSender.sendNEC(sAddress, sCommand, sRepeats);   delay(1000); } download arduino IDE source code file:    Uair_IR_send.zip (Size: 388 bytes / Downloads: 292) Note: install "IRremote" library online firstly. set IR sender and receiver GPIO pins define as below image: