+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-A4 (https://www.kincony.com/forum/forumdisplay.php?fid=21)
+--- Thread: [Arduino demo source code for KC868-A4]-02 433MHz RF signal receive decode (/showthread.php?tid=1641)
[Arduino demo source code for KC868-A4]-02 433MHz RF signal receive decode - KinCony Support - 01-07-2022
Code 1: //The demo code is RF-receive You can copy the code to your Arduino IDE
Code:
#include <RCSwitch.h>
RCSwitch mySwitch = RCSwitch();
void setup() {
Serial.begin(9600);
mySwitch.enableReceive(digitalPinToInterrupt(19)); //IO19
Serial.print("begin test");
}
void loop() {
if (mySwitch.available()) {
Serial.print("Received ");
Serial.print( mySwitch.getReceivedValue() );
Serial.print(" / ");
Serial.print( mySwitch.getReceivedBitlength() );
Serial.print("bit ");
Serial.print("Protocol: ");
Serial.println( mySwitch.getReceivedProtocol() );
mySwitch.resetAvailable();
}
}