+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: KC868-Server Raspberry Pi4 local server (https://www.kincony.com/forum/forumdisplay.php?fid=17)
+--- Thread: [Arduino IDE demo source code for KC868-SERVER]--#01-433Mhz-RF-RECEIVE code (/showthread.php?tid=1847)
[Arduino IDE demo source code for KC868-SERVER]--#01-433Mhz-RF-RECEIVE code - KinCony Support - 04-21-2022
Code:
#include <RCSwitch.h>
RCSwitch mySwitch = RCSwitch();
void setup() {
Serial.begin(9600);
mySwitch.enableReceive(digitalPinToInterrupt(13)); //The receive PIN is IO 13
}
void loop() {
if (mySwitch.available()) {
Serial.print("Received ");
Serial.print( mySwitch.getReceivedValue() );
Serial.print(" / ");
Serial.print( mySwitch.getReceivedBitlength() );
Serial.print("bit ");
Serial.print("Protocol: ");
Serial.println( mySwitch.getReceivedProtocol() );
mySwitch.resetAvailable();
}
}