Smart Home Automation Forum
switch terminal board v2 and KC868 - Printable Version

+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: KC868-HxB series Smart Controller (https://www.kincony.com/forum/forumdisplay.php?fid=2)
+--- Thread: switch terminal board v2 and KC868 (/showthread.php?tid=205)



switch terminal board v2 and KC868 - joyrox12 - 01-27-2021

Is it possible to use terminal switches as digital inputs?

I was not interested in that they were tied to the relay outputs, I wanted to assign them the outputs in nodered.
thanks


RE: switch terminal board v2 and KC868 - admin - 01-28-2021

if your Node-Red is installed on raspberry pi. ok, no problem, let your switch terminal board connect to PI by USB port (use a usb rs232 adapter), then you can get the message that any key pressed by Node-Red.


RE: switch terminal board v2 and KC868 - joyrox12 - 02-01-2021

I can send kc868 through rs232 but when I connect to the terminal switch I get no response ... what am I doing wrong?
thanks


RE: switch terminal board v2 and KC868 - admin - 02-02-2021

check your pin define, use RS232's pin2,pin3,pin5, maybe you need exchange the pin2 and pin3.


RE: switch terminal board v2 and KC868 - joyrox12 - 02-03-2021

(02-02-2021, 12:09 AM)administración Wrote: verifique la definición de su pin, use el pin2, pin3, pin5 de RS232, tal vez necesite cambiar el pin2 y el pin3.

He invertido el pin RX TX pero todavía no puedo leer las entradas en nodered


RE: switch terminal board v2 and KC868 - admin - 02-04-2021

can you take a photo , how you wire.