+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: "KCS" firmware system (https://www.kincony.com/forum/forumdisplay.php?fid=40)
+--- Thread: how to use "KCS" firmware for KinCony ESP32 board (/showthread.php?tid=2531)
how to use "KCS" firmware for KinCony ESP32 board - admin - 01-22-2023
Note: This protocol document use for KinCony ESP32 smart controller:
KC868-A4 KC868-A6 KC868-A8 KC868-A8S KC868-A16 KC868-E16S KC868-A32 KC868-A64 KC868-A128 smart controller
Different board will have different channel of digital output, digital input , ADC, DAC, so the protocol is same , just according to the hardware resource to set channel number.
"KCS" onliine guide: https://www.kincony.com/kcs-firmware-esp32-board.html
KCS_user_guide_v1.0.pdf (Size: 901.95 KB / Downloads: 568)
RE: how to use "KCS" firmware for KinCony ESP32 board - Elvi Bualoy - 07-19-2023
Hi Admin and All Member,
Im not sure if anyone have the same issue as I have. Im using a KC868-E16S I manage to upload the firmware and open the webpage. What I notice is every time I go to protocol-->general--> and enable the MQTT, Http server, TCP server, UDP Server and RS485 and then SAVE every time it restart or reset, I cannot anymore connect to the web page and even its wifi. Appreciate if you could check on this one. Thank You.
RE: how to use "KCS" firmware for KinCony ESP32 board - admin - 07-19-2023
if not used protocol, disable it. after you download, remove your USB-C cable is better.