[Arduino source code for KC868-AM]-05 WIFISCAN_RSSI

Code:
/*  KC868-AM wifi scan and print the RSSI*/





#include "WiFi.h"



void setup()

{

    Serial.begin(115200);



    // Set WiFi to station mode and disconnect from an AP if it was previously connected

    WiFi.mode(WIFI_STA);

    WiFi.disconnect();

    delay(100);

}



void loop()

{

    Serial.println("scan start");



    // WiFi.scanNetworks will return the number of networks found

    int n = WiFi.scanNetworks();

    Serial.println("scan done");

    if (n == 0) {

        Serial.println("no networks found");

    } else {

        Serial.print(n);

        Serial.println(" networks found");

       

       for (int i = 0; i < n; ++i) {

          /*Print SSID and RSSI for each network found

            Serial.print(i + 1);

            Serial.print(": ");

            Serial.print(WiFi.SSID(i));

            Serial.print(" (");

            Serial.print(WiFi.RSSI(i));

            Serial.print(")");

            Serial.println((WiFi.encryptionType(i) == WIFI_AUTH_OPEN)?" ":"*");

            delay(10);*/

            if(WiFi.SSID(i)=="KinCony"){

            Serial.print(WiFi.SSID(i));

            Serial.print(" (");

            Serial.print(WiFi.RSSI(i));

            Serial.println("db)");

            delay(100);

        }

        }

    }

    Serial.println("");



    // Wait a bit before scanning again

    delay(1000);

}